- Fault codes
- 26
- Block
- C1
- Make group
- Changan · Deepal
- Source language
- English
The 26 Changan · Deepal fault codes that start with C1, with descriptions.
| Code | Description |
|---|---|
C1600 | EPS power supply overvoltage (generator fault / vehicle starts abnormally) |
C1601 | EPS power supply undervoltage (poor connection between battery and EPS / battery is dead) |
C1602 | EPS abnormal power failure (battery voltage abnormality / EPS restart) |
C1603 | Abnormal torque / angle sensor power supply (5V / 3.3V equal voltage overvoltage or undervoltage / short circuit to ground or VCC / voltage overload / component fault) |
C1604 | Torque output 1 fault (sensor power supply abnormality / flarness fault / control circuit fault) |
C1605 | Torque output 2 fault (sensor power supply abnormality / flarness fault / control circuit fault) |
C1606 | Torque output 1 and 2 correlation fault (T1 / T2 torque sensor differs greatly) |
C1607 | Torque sensor calibration error / not calibrated |
C1608 | Motor rotor position sensor power supply / excitation fault (voltage supply is too low / too high) |
C1609 | Motor rotor position signal fault (sensor open circuit / ADC signal invalid) |
C160A | Motor rotor position signal correlation fault (Die1 / Dle2 is quite different) |
C160B | Steering wheel angle and motor rotor position correlation fault (sensor short circuit or open circuit / motor coupling or bearing damage) |
C160C | EPS corner signal fault (sensor power supply abnormality / harness fault / sensor fault) |
C160D | EPS corner signal correlation fault (sensor power supply abnormality / harness fault / sensor fault) |
C160E | EPS angle median not calibrated (no angular median calibration / angle center storage fault) |
C160F | Motor circuit fault - phase current (three-phase voltage difference exceeds calibration value) |
C1610 | Motor circuit fault - current deviation (ADC fault) |
C1611 | Motor circuit fault - door drive (door drive chip faulty / FET open circuit / door drive chip monitoring fault) |
C1612 | ECU fault - unexpected interrupt (program execution interrupted / debugging tool connection exists) |
C1613 | ECU fault - CPU (Incorrect hardware configuration) |
C1614 | ECU fault - clock (CLMA hardware configuration incorrect / internal oscillator interference normal timing) |
C1615 | ECU fault - program execution (program execution interrupted / debugging tool connection exists) |
C1616 | ECU fault - memory (memory corruption / incorrect parameter configuration) |
C1617 | Commissioning calibration not selected (configuration code not written) |
C1618 | EPS thermal protection triggering (too many cycles, touch fever protection) |
C1619 | System fault (abnormal current torque) |
Other blocks
Makes that use these codes
Code descriptions are shown in their source language; records without a translation stay raw. Source: CarCoding fault code database.
Get CarCoding
Connect your ELM327 adapter, read fault codes, and browse module settings on supported vehicles.
The app is free to download.